Systems Engineering and Electronics ›› 2019, Vol. 41 ›› Issue (1): 43-49.doi: 10.3969/j.issn.1001-506X.2019.01.07

Previous Articles     Next Articles

Detection method for weak target under unknown strong clutter based on DP-TBD

ZHONG Lei1, LI Yong1, MOU Zhiying2, CHENG Wei1, LI Haobin1   

  1. 1. School of Electronic Information, Northwestern Polytechnical University, Xi’an 710072, China;
    2. China National Aeronautical Radio Electronics Research Institute, Shanghai 200233, China
  • Online:2018-12-29 Published:2018-12-27

Abstract:

The heterogeneous or complex clutter in real environment is usually encountered by detection of weak target. It may be difficult for track-before-detect (TBD) based on modeling of clutter to detect weak target, when the signal-to-clutter ratio (SCR) is low, or prior information and clutter distribution is difficult to obtain. A new detection algorithm is proposed for real data of unknown strong clutter. The improved greatestof constant false alarm rate (CFAR) is used to preprocess the clutter according to the features of unknown distribution, clutter edge, etc. Then twodimensional data of Doppler-distance is compressed to avoid accumulation of clutter in the same unit after association of multiframe. Finally, the dynamic programmingbased TBD algorithm is improved in the time-distance space to avoid expansion of clutter in different range units and to eliminate false alarms after jointed multiframe. Experimental results show that the proposed algorithm has higher detection probability and lower estimation error than conventional TBD methods.

[an error occurred while processing this directive]