系统工程与电子技术 ›› 2023, Vol. 45 ›› Issue (4): 1127-1133.doi: 10.12305/j.issn.1001-506X.2023.04.21

• 制导、导航与控制 • 上一篇    

多视图融合的无人机定位方法

庞阳1, 王明2,*, 闫子仪3, 岳童尧4, 周哲1   

  1. 1. 北京航空航天大学仪器科学与光电工程学院, 北京 100191
    2. 北京航空航天大学无人系统研究院, 北京 100191
    3. 航空工业西安飞行自动控制研究所, 陕西 西安 710018
    4. 北京控制与电子技术研究所, 北京 100082
  • 收稿日期:2022-04-24 出版日期:2023-03-29 发布日期:2023-03-28
  • 通讯作者: 王明
  • 作者简介:庞阳 (1995—), 男, 博士研究生, 主要研究方向为惯性导航、视觉导航、地磁匹配、无人机协同导航等组合导航
    王明 (1985—), 男, 助理研究员, 博士, 主要研究方向为无人机集群技术
    闫子仪 (1996—), 女, 助理工程师,硕士, 主要研究方向为惯性导航
    岳童尧 (1996—), 女, 助理工程师,硕士, 主要研究方向为惯性导航
    周哲 (2000—), 男, 硕士研究生, 主要研究方向为协同导航、地磁导航等组合导航

UAV localization method with multi-view fusion

Yang PANG1, Ming WANG2,*, Ziyi YAN3, Tongyao YUE4, Zhe ZHOU1   

  1. 1. School of Instrument Science and Optoelectronic Engineering, Beihang University, Beijing 100191, China
    2. Institute of Unmanned Systems, Beihang University, Beijing 100191, China
    3. Xi'an Flight Automatic Control Research Institute, Xi'an 710018, China
    4. Beijing Institute of Control and Electronics Technology, Beijing 100082, China
  • Received:2022-04-24 Online:2023-03-29 Published:2023-03-28
  • Contact: Ming WANG

摘要:

无人机(unmanned aerial vehicle, UAV)技术已广泛应用于军民领域。在预警、飞行控制和轨迹跟踪过程中需要导航设备提供准确的位置信息, 传统的单目视觉测量无法准确获取目标的深度信息, 双目视觉测量方法受距离和视角影响测量精度低。针对这一问题, 提出了多相机全方位的多视图融合定位的方法, 以成像面积最大的摄像机为主, 两侧相机为辅, 采用物点定位法分别计算UAV的三维信息, 并将平均值作为UAV的定位信息。最后, 通过实验验证, 多视图融合的物点测量方法可实现3 cm的定位精度。

关键词: 无人机, 多视图融合, 定位, 物点定位

Abstract:

Unmanned aerial vehicle (UAV) technology has been widely used in military and civilian fields. In the process of early warning, flight control and trajectory tracking, navigation equipment is required to provide accurate position information. Traditional monocular vision measurement cannot accurately obtain the depth information of the target, and binocular vision measurement method is affected by distance and viewpoint with low measurement accuracy. To address this problem, a multi-camera all-round multi-view fusion positioning method is proposed, in which the camera with the largest imaging area is the main one and the cameras on both sides are supplemented, and the object point positioning method is used to calculate the 3D information of the UAV respectively, and the average value is used as the positioning information of the UAV. Finally, through experimental verification, the multi-view fusion object point measurement method can achieve a positioning accuracy of 3 cm.

Key words: unmanned aerial vehicle (UAV), multi-view fusion, positioning, point-of-object positioning

中图分类号: